In the previous post we had a brief introduction of the installation of cross roller guides, now the specific steps of the installation are listed for reference.
The crossed roller guideway is composed of two guideways with V-shaped raceways, cylindrical rollers in the roller cage, etc. The cylindrical rollers arranged cross each other reciprocate on the precision-ground V-shaped raceway surface, which can withstand Loads in all directions to achieve high-precision, smooth linear motion.
1. Use a degreasing agent to wipe off the anti-rust oil on the reference surface of the part. Since the reference surface from which the anti-rust oil has been removed is prone to rust, it can be used with low-viscosity paint.
2. After the side base surfaces of parts 1~3 are placed on the side base surface of the positioning step, pre-fix them on the base of the bed and the slide table with screws. The tightening force should not be too large, so that the bottom surface of the parts is closely connected with the relative base surface. That's it.
3. Temporarily fix part 4 on the adjustment side.
4.Carefully insert the retainer near the center.
5. Install the end stop on the end of the rail.
6. Move the slider left and right to the end, and adjust the cage to the center of the bed.
7.Hit the meter head on the center and side of the slide table.
8.Move the slide table to the end of one side, and after confirming that there is a roller directly opposite the adjusting bolt, tighten the adjusting screw lightly.
9.Move the slide table to the end of the other side, and tighten it lightly as above.
10.Move the slide table to the central position, and lightly tighten the adjusting screw.
11. Repeat steps 8-10 to adjust the clearance of the slide table to 0.
12. Referring to the torque values given in the table below, tighten the adjusting screws according to steps 8-10.
13.Finally, fasten part 4. Similar to the tightening procedure of the adjusting screw, move the slide table so that the place where the bolt is tightened is facing the roller.
If the indications above do not fit the installation environment of unique situation of clients, PINSI could provide professional technical support including the installation guidance for our clients if they need.
Feel free to contact us for the technical questions！
Contact: Jimmy Zheng
+8615622924499
+8615622924499
